Wanted Clutch arm

S

stevenl

Silver forum user
CAT Member
Messages
51
I'm looking for a clutch arm for a OEM 260, did I mention reasonably priced. If anyone knows of an aftermarket replacement that works I'd be happy to get that information as well. Cheers everybody 😊🐯😸
 
There is a common 9-1/4" Ford arm that approximates the OEM needs. Can't recall the parts' source but I was able to drill the spring clip hole and make use of Tiger hardware. I've seen more confab about this somewhere (maybe here?)
 
Thanks for getting back to me on that, hoping to get more information for others concerning the clutch arm, part numbers will be helpful. Thanks again 🙂😸
 
Other guru Dan said that they come in long and short.
I gave Dan one at a swap meet some time ago.
Later this week I'll post a picture and a measurement of one I have for comparison. I need to figure out which I have .
Only because I have an orphan 289 5 bolt motor.
 
Last edited:
You must log in or register to reply here.
Back
Top