- Messages
- 406
Selling spare parts from my Hoakenson (Toyz Junkie) front end.
All parts were mounted but not used so some scuffs but otherwise new.
These will NOT fit stock Tiger, but will if you want to upgrade an existing Mustang 2 suspension car (Tiger or otherwise) this is a good starting point.
Mustang 2 drop spindles
Wilwood Aluminum Hubs and Bearings
ARP long wheel studs for each hub
K772 Ball Joints 4x (needs dust shields)
Slotted Rotors Wilwood 1.25"x12.19" GT 48 Curved Vane
Wilwood Aluminum Hats
Wilwood Superlite 6 Piston Calipers
Wilwood Caliper to Mustang II mounts
New set of street pads, and set of street/strip pads that were used about 1/16"
Looking to get $1300 for everything, no tax, not duties. As always I reserve the right to sell and to whom I sell too. Your mileage may vary.
For starters pick up only in Los Angeles area.
All parts were mounted but not used so some scuffs but otherwise new.
These will NOT fit stock Tiger, but will if you want to upgrade an existing Mustang 2 suspension car (Tiger or otherwise) this is a good starting point.
Mustang 2 drop spindles
Wilwood Aluminum Hubs and Bearings
ARP long wheel studs for each hub
K772 Ball Joints 4x (needs dust shields)
Slotted Rotors Wilwood 1.25"x12.19" GT 48 Curved Vane
Wilwood Aluminum Hats
Wilwood Superlite 6 Piston Calipers
Wilwood Caliper to Mustang II mounts
New set of street pads, and set of street/strip pads that were used about 1/16"
Looking to get $1300 for everything, no tax, not duties. As always I reserve the right to sell and to whom I sell too. Your mileage may vary.
For starters pick up only in Los Angeles area.