Side Molding Question

[66Tiger289]

What are the measurement of the two rivet holes for the small side molding after the TIGER Script measured from the fender's edge. See picture Below.

Thanks

 

[cobrakidz]

Not sure, I just guessed when we did my friend's Get Smart clone......from the back edge of the fender I did 1" and 2 3/4".

 

[tonythetiger]

side moulding ??

I think I can help. IF you will give me a day or two to get into storage and then uncover the car- the moulding is off and the holes or ones with original rivets still protruding are. I need to measure all of them as this question arises on and off.
TonytheTiger

 

[bill37341]

On B382000521, holes are at 1 3/8 & 2 3/4. Hope this helps, Bill.

 

[cobrakidz]

Good to see we were close on ours......

 

[66Tiger289]

Thanks Tony

Thanks Bill

Thanks Bruce

 

[cobrakidz]

Hey what about me ??? haha

 

[DD (CA)]

Photo corroboration

(Always need more pictures...)