Master Kill Switch Box

[sandy]

After reading some old discussion about safety I decided to not rely on reaching to the dash to turn the switch to off. Difficult in a full harness to lean in. So added a Hammond Mfg. aluminum box with a couple of switches. One for master power not sure about the other yet. Mounting around the shifter or rear of it depending where is easiest to reach.

Some issues with the hardware as it seems Hammond felt it was OK to powdercoat the threads to. Need a metric tap set which oddly I don't have.

 

[sandy]

Waiting on the grommet/strain relief from McMaster I wired up one end of the harness with Metri-pack 150 connector. Will add one to the dash harness. Extra switch wires for second switch too.