Hi all,
The separator plate that came off of my Tiger had a rubber seal around the large hole in the centre which appears to butt up against the back of the engine block presumably to keep any loose oil at the engine side.
The seal on my plate is in very poor condition.
I wondered, do people replace this seal or just remove it and use the plate without?
Also, would it cause any harm to spray paint the separator plate? It somehow seems wrong not to protect it in some way.
And lastly, in one of the rocker covers, beneath the PCV, there is a small 'enclosure' with what looks like course wire wool inside it that acts as a filter.
Is it possible to buy replacements of these?
Many Thanks.
The separator plate that came off of my Tiger had a rubber seal around the large hole in the centre which appears to butt up against the back of the engine block presumably to keep any loose oil at the engine side.
The seal on my plate is in very poor condition.
I wondered, do people replace this seal or just remove it and use the plate without?
Also, would it cause any harm to spray paint the separator plate? It somehow seems wrong not to protect it in some way.
And lastly, in one of the rocker covers, beneath the PCV, there is a small 'enclosure' with what looks like course wire wool inside it that acts as a filter.
Is it possible to buy replacements of these?
Many Thanks.