gregory schumacher
Bronze forum user
- Messages
- 25
Does anyone make the channels that hold the molding on the bottom of the hardtop? Restoration is just beginning good by rust.
Hardtop
- Thread starter gregory schumacher
- Start date
Warren
Gold forum user
- Messages
- 3,872
Straighten
Randy W. Had suggested removing a door channel and making it straight.
I have not tried this but I have a similar project requiring the same.
I guessing that there is a similar channel out there somewhere. I was just looking at one of my hard tops the other day and I was wondering why they would put that little bitty Channel piece underneath the corner pad right on top of the drain holes in C pillar.
Below is a quote from a Fakebook posting. Might be pretty $ at a Land Rover dealer/
M. Clark The seal channel is the same on a Range Rover tail gate they come about 1 metre length try your Land Rover dealer
Randy W. Had suggested removing a door channel and making it straight.
I have not tried this but I have a similar project requiring the same.
I guessing that there is a similar channel out there somewhere. I was just looking at one of my hard tops the other day and I was wondering why they would put that little bitty Channel piece underneath the corner pad right on top of the drain holes in C pillar.
Below is a quote from a Fakebook posting. Might be pretty $ at a Land Rover dealer/
M. Clark The seal channel is the same on a Range Rover tail gate they come about 1 metre length try your Land Rover dealer
Last edited: